Boot is designed to allow pipe to penetrate liner; has seaming adhesive preapplied to bottom.

Fits 1” - 6” pipe.

SEAMING LINER

The
liner must be clean and dry in order to seam. Overlap approx. 6+” of the
liner to be seamed. Scrub the area to be seamed with clean water or
white gasoline, cleaning both liner pieces past where the seam tape will
attach. Let dry. Place a
narrow strip of plywood under overlap for
support while seaming. Use scrub pad to evenly apply QuickPrime Plus
past where the tape will attach. Let dry to the point that it is tacky;
not dry, not wet to the point of stringing out when touched.
Apply 6”
wide single-sided tape to EPDM; (for large jobs, use 3” double-sided
tape between overlapped EPDM first, then 6” over the top). Press
together with a small silicone roller, pressing hard in all directions.
Warm seam in sun or with hair dryer.
Let bond 24 hours then fill.